Securing GB motor magnets

[dennis vollrath]

I've used the following process for mounting the GB motor magnets.
1. Sand the inside of the magnet ring
2. Place magnets in place around the magnet ring
3. Place a drop of thin CA on magnets to secure in place
4. Obtain plain old Baking Soda from the kitchen
5. Set the magnet ring horizontal
6. Fill in the space between the magnets at the bottom of the ring with
baking soda
7. Clear out the baking soda overfill with a cue-tip or similar
8. Do not allow the baking soda to pile up higher than the magnets!
9. Place a small drop of CA on the baking soda
10. The CA will set instantly, and will be very difficult to remove

This is a very old CA trick. I have not had any magnets come loose, even under very extenuating circumstances.