HELP GUYS

[outrunner]

Guys, I wind alot of simples motor already. But when it get to this.. it get complicated.

I have an AXI 2820-10, It was running good.. .untill one of the wire got completely yank off and can't be repair.. so i make a stupid mistake by unwinding it.. and thought that i might be able to rewind it... :D bad idea.

Now it completely mess up. even the stator is now mess up... hehe.

What can I do now? Will that new stator fit? I do have a few 22.2mm, but they're a bit smaller... so probably that 25 will do it?

BUT what kind of configuration of wind? for a 12 pole? and I it 14magnet pole to? I did try to wind it with LRK style before i mess up the stator... and it did not went well... the thing just sit there and smookin.

What wire guage, number of turn, wind config, for arround 1000kv

Thanks guys

[swatson144]

I have to assume the 28 means 28 mm stator, the 20 means 20mm stack and the -10 means 10turns. How bad could you have messed up the stator? The winding for a 12 arm 14 pole would be AabBCcaABbcC from here http://www.powerditto.de/Kombinationstabelle2.html. I'd use the same size wire it had.