PDA

View Full Version : will this work

kevinpelletier
10-08-2004, 10:07 PM
i was just wondering if this setup was useable or not its the motor for the floppy drive its a 14 tooth stator the thin wire is 120t any input would be great. i was planing on using the original outer can
ron_van_sommeren
10-11-2004, 05:23 AM
Number of statorteeth must be a multiple of 3. Alas, 14 cannot be used.
Happy|Harry
10-11-2004, 09:36 AM
i was just wondering if this setup was useable or not its the motor for the floppy drive its a 14 tooth stator the thin wire is 120t any input would be great. i was planing on using the original outer can

kevin i count 15 if you include the unwound teeth :?

phil
ron_van_sommeren
10-11-2004, 09:42 AM
15 statorteeth, 10magnets for rpm, 20 for torque, wind ABCABCABCABCABC.
kevinpelletier
10-11-2004, 12:55 PM
sorry about that it is 15 tooth stator. another question for you guys is anybody making a kit where the shaft is the part that rotates and nott he case
Happy|Harry
10-11-2004, 02:06 PM
sorry about that it is 15 tooth stator. another question for you guys is anybody making a kit where the shaft is the part that rotates and nott he case

i think your talking about an inrunner(Lehner/Hacker/Himax etc)?, and i know of no kit's, ron may know as he's the go-to guy for diy brushless :D

phil